Who's good in Fusion360?

Discussion in 'Tech Support' started by DirectorGunner, Jul 13, 2018 at 10:26 AM.

  1. DirectorGunner

    DirectorGunner Grand Admiral
    Donor

    Joined:
    Sep 17, 2016
    Messages:
    1,611
    Likes Received:
    6,911
    RSI Handle:
    DirectorGunner
    I'm making an Xbox One controller wall mount...
    And.. instead of using a mesh of an Xbox One controller to subscract from the solid model (gives the polygons you see below) I'd like to actually model the depression I need in my mount to snuggly mount the controller.

    How can I do a crazy ass dynamic sweep to get that approximate cutout on both sides?
    I know how to do sweeps well, but this is just lots of crazy angles...

    [​IMG]

    @RiceMaiden you're a modeling guru... any ideas?
     

Share This Page