Howdy all,
So I've come up against something a little out of my wheel house concerning 3D modeling.
I converted the Bar Citizen Logo png to a vector (it's not perfect but it's close)
And then when extruding the vector
I couldn't use cap fillet, only fillet on some of the paths (see pic below)
The red marks shows the shapes I need to cap, however if I try to cap these they get all messed up.
It doesn't make sense to me because the edges are continuous on the end of the fillets.
Anyone suggestions on how to fix this?
Thank you
So I've come up against something a little out of my wheel house concerning 3D modeling.
I converted the Bar Citizen Logo png to a vector (it's not perfect but it's close)
And then when extruding the vector
I couldn't use cap fillet, only fillet on some of the paths (see pic below)
The red marks shows the shapes I need to cap, however if I try to cap these they get all messed up.
It doesn't make sense to me because the edges are continuous on the end of the fillets.
Anyone suggestions on how to fix this?
Thank you